Sizing
How many amps does a woodshop need in a garage
The woodshop package that fits a 22 x 22 ft garage needs 7 circuits (1 at 240V), about 40 A of demand on a 240V-equivalent basis, and a 60 A subpanel to ask your electrician about.
The circuit list
| Circuit | Volts | Breaker | Wire | Receptacle |
|---|---|---|---|---|
| Cabinet table saw | 240 V | 20 A | 12 AWG | NEMA 6-20R |
| 14 in bandsaw | 120 V | 20 A | 12 AWG | NEMA 5-20R |
| Cyclone dust collector | 120 V | 20 A | 12 AWG | NEMA 5-20R |
| Tool bench (Jointer, Planer, Drill press) | 120 V | 20 A | 12 AWG | NEMA 5-20R |
| Miter saw station | 120 V | 20 A | 12 AWG | NEMA 5-20R |
| 20 gallon compressor | 120 V | 20 A | 12 AWG | NEMA 5-20R |
| Shared bench circuit 1 | 120 V | 20 A | 12 AWG | NEMA 5-20R (several) |
240V machines each get a dedicated circuit sized at 125 percent of their running amps; 120V machines at 10 A or more get their own 20 A circuit; small loads share bench circuits. Wire is copper on the NM-B ampacity column (NEC Table 310.16, 60 C). These are planning sizes: a licensed electrician confirms every one.
Why that subpanel
Connected load adds to 52 A in 240V-equivalent terms, but a shop rarely runs everything at once: counting the largest load in full and the rest at a diversity factor gives about 40 A, and with the 125 percent rule a 60 A subpanel. The package is: Cabinet saw, Bandsaw, Cyclone, Tool bench, 6 ft bench, Miter station, Shelving, Compressor. Table saw, bandsaw, jointer, planer, dust collection and a bench.
Use the workshop amps calculator to change the machines, and open the 22 x 22 woodshop layout to see where each one sits.
Shop for this size
Matched to the result above.
Prices change often; the button shows today's price on Amazon.
Get the garage shop planning checklist
One printable page: measure the bay, count the circuits, list the machines, check the floor. Plus a few short emails, then a couple a month at most.
Unsubscribe anytime. You can also just read the checklist on this site.Subpanel by trade: the other answers
- How many amps does a machine shop need in a garage
- How many amps does a welding and fab need in a garage
- How many amps does a auto and mechanic need in a garage
- How many amps does a mixed shop with a car parked need in a garage
Frequently asked questions
Do I need 240V for a woodshop?
Yes for at least one machine in this package. Heaters, large compressors, collectors over 2 HP and most welders are happier on 240V; the 240V circuit calculator sizes each.
This page is researched guidance, not professional electrical, engineering or safety advice. Circuits, loads and clearances depend on your house, your service and your town: have a licensed electrician confirm any wiring, and check local code and each manufacturer's manual before you act.
